RGB CCT COB LED Strip Light | 960 LEDs Per Metre, Colour and Tunable White
Save $-176.00
In stock
Ask An ExpertSubtotal: $176.00
Fast Delivery: USPS Priority Mail
- Flat Rate Shipping
- Secure Checkout — SSL Encrypted
Frequently Bought Together
Total: $249.12
| Density | 960 LEDs per metre |
|---|---|
| Board width | 12mm |
| Channels | RGB plus tunable white |
| Colour rendering | Ra90 |
| Voltage | 24V DC |
| Rating | IP20 indoor, or IP65 and IP67 sealed |
- Decide if you need colour and white - RGB CCT gives both properly. Plain RGB makes a mixed white that colours will not read correctly under.
- Pick the IP rating - IP20 for dry indoor coves and cabinets, IP65 or IP67 for bathrooms, kitchens near a sink and covered outdoor areas.
- Buy a five channel controller - RGB CCT uses five channels. A three channel RGB controller will run the colours and leave the white emitters dark.
- Use a 24V driver - sized to watts per metre times run length, plus 20 percent.
- Fit it in an aluminium channel - the 12mm board needs a channel wide enough, so check the internal dimension.
- Cut only at the marked points.
- Test every mode before closing up - run through colour, warm white and cool white across the full length.
Colour and proper white light in one run
Plain RGB tape mixes red, green and blue. It can make something that reads as white, but it is a mixed white and colours in the room will not look right under it. RGB+CCT solves that by adding dedicated warm and cool white channels alongside the colour ones.
The result is one run of tape that does two jobs properly: a tunable white from warm to cool for everyday light, and the full colour range when you want it.
Specification
| Density | 960 LEDs per metre |
| Board width | 12mm |
| Channels | RGB plus tunable white |
| Colour rendering | Ra90 |
| Voltage | 24V DC |
| Rating | IP20 indoor, or IP65 and IP67 sealed |
Comparing the strip types
| Tape | Colour | White quality | Buy it for |
|---|---|---|---|
| Single CCT | No | Correct | Coves, cabinets, everyday light |
| RGB | Yes | Mixed, not accurate | Effects only |
| RGB+CCT | Yes | Correct, and tunable | One run doing both |
Picking the IP rating
IP20 is bare tape for dry indoor runs — coves, shelving, cabinets. IP65 and IP67 are sealed in silicone for bathrooms, kitchens near a sink, covered outdoor areas and anywhere that gets cleaned with water. Sealed tape is harder to cut and slightly dimmer, so only pay for it where it is needed.
960 LEDs per metre
That density is double the standard tape. It matters most on a 12mm board carrying five separate channels, where lower density would show as visible separation between the colour and white emitters. At this density the line stays solid whatever it is doing.
You will need a controller
RGB+CCT uses five channels, so it needs a controller built for five. A plain RGB controller will drive the colour channels and leave the white ones dark. Check the channel count before you order.
Related
You will need a 24V driver and an aluminium channel. For white light only, see our Ra90 COB tape.
